Effectiveness of Traffic Barriers on Non-Level Terrain

The objective of this project is to produce comprehensive recommendations for placement of barriers on roadside and median slopes. The guidelines should address all of the common types of barriers used in the United States. The simulation work is approximately halfway complete to develop a crash testing plan. In the 1970s, an analysis of barriers placed on slopes indicated that most guardrails do not perform well when placed on 1:6 or steeper slopes. Since that time, the vehicle fleet has changed dramatically, with the popularity of light trucks and sport utility vehicles increasing dramatically. Further, there has been a significant change in the design of roadside barriers in recent decades. High-tension cable barriers are beginning to gain widespread acceptance, and there have been changes to the traditional W-beam barriers. It is unclear how these changes affect the behavior of longitudinal barriers placed on slopes. Information from the National Highway Transportation Safety Administration (NHTSA) Fatality Analysis Reporting System (FARS) database indicates that some cross-median crashes have occurred where median barriers were in place. Further, a full-scale crash test has shown that a passenger vehicle can penetrate a cable barrier on the back-slope of a depressed median. With the dramatic increase in use of barriers in depressed medians, a more detailed study of the performance of barriers in depressed medians is needed to achieve acceptable safety performance. The scope of this study does not include barrier terminals. Research tasks are as follows: Task 1. Conduct simulation modeling in accordance with the approved plan developed in National Cooperative Highway Research Program (NCHRP) Project 22-22. Refine the plan for crash testing. Submit a technical memorandum detailing the results of the simulation modeling and including the refined crash testing plan. Work may proceed while this memorandum is reviewed by NCHRP. Task 2. Conduct crash testing in accordance with the refined plan to verify the results of the simulation modeling. Task 3. Submit a final report that describes the research effort and includes placement guidelines for common types of roadside and median barriers on slopes to provide adequate safety performance for impacting vehicles. The report should include specific recommended changes to the American Association of State Highway and Transportation Officials (AASHTO) Roadside Design Guide. Video of the simulation modeling and crash tests should be included on a CD-ROM or DVD.


  • English


  • Status: Active
  • Funding: $420742.00
  • Contract Numbers:

    Project 22-22(02)

  • Sponsor Organizations:

    Federal Highway Administration

    1200 New Jersey Avenue, SE
    Washington, DC  United States  20590

    American Association of State Highway & Transportation Officials (AASHTO)

    444 North Capitol Street, NW, Suite 225
    Washington, DC  United States  20001

    National Cooperative Highway Research Program

    Transportation Research Board
    500 Fifth Street, NW
    Washington, DC  United States  20001
  • Project Managers:

    Derr, B

  • Performing Organizations:

    Texas A&M Research Foundation, College Station

    Texas A&M University
    College Station, TX  United States  77843
  • Principal Investigators:

    Bligh, Roger

  • Start Date: 20120612
  • Expected Completion Date: 0
  • Actual Completion Date: 20141211
  • Source Data: RiP Project 37762

Subject/Index Terms

Filing Info

  • Accession Number: 01543708
  • Record Type: Research project
  • Source Agency: Transportation Research Board
  • Contract Numbers: Project 22-22(02)
  • Files: TRB, RIP
  • Created Date: Nov 20 2014 1:03AM